Home > Craft Materials > Tools > Other Tools > Silicone Transfer Film Approx.12.5"x36"sheet (MJ-74509582)

Silicone Transfer Film allows you to apply complex hot-fix rhinestone designs without leaving any residue.

STEP 1: Draw or print out the design you want to make. Remember that the design will be reversed when applied, so you need a mirror-image of your finished design. Tape the corners to a hard, flat surface.
STEP 2: Cut transfer film slightly larger than the design. Peel off white backing and discard.
STEP 3: Tape corners of the clear film (sticky side up toward you) over the printed design. Choose the color rhinestones you want to use.
STEP 4: Use tweezers to pick up each rhinestone and place it over each dot in the design. Make certain the colors are in the correct area of the design, and make sure the rhinestones are glue side up (therefore upside-down)!
STEP 5: Pick up completed motif and make certain all rhinestones are in the right place.
STEP 6: Place completed design exactly where you want it on your garment, the glue side of rhinestones facing down.
STEP 8: Preheat iron to temperature required for your fabric (approx 280 - 300 degrees) Allow approximately 12 to 15 seconds for 3mm or 4mm rhinestones (more time for larger stones).
STEP 9: Allow to cool to touch then slowly peel off transfer film. If any rhinestones are still on the film, replace just this area of film and repress for 5 to 8 seconds.